Flash F7000050, User Manual

Page: 3 / 10

www.flash-butrym.pl
2
1 INTRODUCTION
Thank you for purchasing LED PAR 64 18x10W RGBW 4in1 ABS 140W. For safety reasons and to ensure the
trouble-free operation, carefully read the instructions.
2 SAFETY INFORMATION
1. Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2. Disconnect the power supply before installation.
3. Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4. Do not use the device in high humidity conditions and at temperatures above 40° C
5. The device must be installed on stable structures
3 PRODUCT INFORMATION
3.1 Specification

Power consumption: 140W

Power supply voltage: 100 - 240V

Voltage frequency: 50/60Hz

Diode type: 4in1

Number of diodes: 18

Diode power: 10W

Display: LED - 4 characters

Color: RGBW

Beam angle (min): 15°

Beam angle (max): 45°

Dimming: Linear: 0 - 100%

DMX standard: DMX 512

Control interface: 4 buttons

Operating modes: DMX, Auto, Master/Slave, Sound controlled

AC IN: IEC - C14

DMX IN: XLR - 3 pin

DMX OUT: XLR - 3 pin

IP Rating: IP20

Housing made: ABS

Cooling: Active
4 INSTALLATION
After removing the packaging, check if the device was not damaged during transport. Before connecting to
the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage
caused by unstable mounting.