www.flash-butrym.pl
Strona
12
ATTENTION
：
：
：
：
RISK OF SHORT CIRCUIT
！
！
！
！
ATTENTION
：
：
：
：
DANGER OF LIFE
！
！
！
！
RISKOF FIRE
！
！
！
！
RISK OF SHORT CIRCUIT
！
！
！
！
and vibration-free surface.The installation of this lighting effect must be carried out by trained and professional
staff!The installation of this lighting must only be carried out with the appropriate materials!
The suspended installation of this lighting effect necessitates a suitable suspension system!The lighting effect must
never be fixed swinging freely in the room.No individuals should linger underneath the lighting effect during
suspended installation!
It is a must to install this device with a second independent fixture.Such second fixture must guarantee in the event
of failure of the main fixture that no assembly parts will fall down.Use the fixture on the undersurface only.
The light effect unit must be attached via two certified hooks and omega bracket to a tie-bar system.Use the screw
threads on the undersurface only.
It must be ensured that an expert inspects the mechanical and safety-relevant installation prior to the initial
operation and following major modifications,prior to the renewed operation.It must be ensured that an expert
inspects the mechanical and safety-relevant installation at least once a year.It must be ensured that an expert
inspects the mechanical installation and the installation of relevance to safety within the framework of an
acceptance test at least every four years.
The installation fixture must be as such that it can withstand for a period of 60minutes 10 times the load capacity
without harmful deformation.
It is prohibited for any individual to unnecessarily stay or pass beneath the installation during any type of assembly
work
.
The light effect unit must be secured by a safety arrester cable if fly-mounted. The cable must withstand 12 times
the weigh of the light effect unit Use arrester cables equipped with quick closing links. The dropping distance must
not exceed 20 cm.Defect arrester cables or arrester cables that have already been exposed to stress must not be
used.
6. Operation
Controls
Link all DMX devices with a DMX-512 controller by using a standard,3-pin DMX cable.Connect the output of the first
device with the input of the second device and the output of the second device with the input of the third device and
so on.
Connect the mains plug to an outlet.
Operating the product for the first time may generate smoke and odour,this is not a defect.Avoid dis/connecting the
product repeatedly and quickly from/with mains!Always wait 15 minutes prior to the next dis/connection!
The device starts not until a self-testing and starting time.If the moving head is ready to start,push and roll the
function wheel.The LCD display shows the options,as below:
7. Lamps
During operation,the lamps will reach temperatures of up to 600
O
C.Touching the lamps may cause serious
burns!Objects coming into contact with the lamps during and shortly after opration may catch fire!
Disconnect the product from mains prior to installing or before changing a lamp! Allow a lamp to cool for
approx.15minutes before exchanging it!
Never touch a lamp with bare hands! If damaged or deformed, a lamp must be exchanged!
When exchanging the lamp be sure to use suitable lamps only.Lamps with greater performance generate excessive
heat for the product; risk of fire! Damage resulting from the use of an unsuitable lamp is exempt from warranty!
