www.flash-butrym.pl
Strona
10
ATTENTION
：
：
：
：
DANGER OF LIFE
！
！
！
！
RISKOF FIRE
！
！
！
！
RISK OF SHORT CIRCUIT
！
！
！
！
FLASH
Congratulations on purchasing this 200W moving
Beam Light
Thank you for extending your trust in our technology!
For reasons of safety and approval(CE) the personal reconstruction and/or modification of this product is prohibited.
Please observe that damage caused by modifications performed manually to this device is not covered by the
warranty.
This product leaves our works in a perfect condition. Please observe all notes in these operating instructions to
warrant this condition and the safe operation of hte product!
Any damage caused as a result of the non-compliance with these operating instructions leads to the expiration of
any warranty claim. The manufacturer does not accept liability for any damage to property or for personal injury
resulting from the improper handling of the product, or non-observance of the operating instructions.
Store these operating instructions in a safe place for later reference and pass them to any new holder when selling
or lending or leaving this device in the hands of any other party.
Application According to Purpose
This product is a lighting effect which creates specila light effects with one lamp.Togenerate these effects,the
product must be connected to mains and a DMX-512 compatible controller.
This product is designed for AC220~240V/50~60Hz operation and exclusively for indoor use.
If used for any purpose other than described in these operating instructions, the device may suffer damage and the
warranty expires.Also,any other use is linked with risks such as short circuits, fire, electrical shock, etc.
The manufacturer's serial number must never be removed as otherwise the warranty expires.
Notes on safety
1. Before Operation
Prior to the initial operation of this
produc,please do the followings
-Read these operating instructions with great care;
-Study and observe all instructions carefully;
-Ensure that everybody and anybody involved in the installation,operation,transport and storage of this product is
suitably qualified;
-Verify whether any visible damage was caused during transport.lf thepower cord.housing or the light are
damaged,do not operate the device;contact your specialized dealer immediately.
2. Supply Voltage,Mains Cord and Connection to Mains
The handling of supply voltage,mains cords and connections to mains calls for particular care considering the
riskfrom a life-threatening electric shock,the risk of fire and the risk of short circuitsl please observe the following
notes in particular:
Products operating on supply voltage should be kept out of the reach of children.Therefore ensure the permanent
supervision if children are in the immediate vicinity of the product!
For commercial facilities the regulations on the prevention of accidents of the respective trade association must be
observed.The operation of this equipment at schools,training facilities,and hobbyorself-help workshops must be
supervised responsibly by trained personnel.
Check the product regularly for any damage to the malns cord! Should you discover any damage to the malns cord,
do not operate or disconnect this product! Secure the product against accidental operation and contact your
specialized dealert.
Always separate the product from mains by holding the mains plug by the handling surface .Never disconnect by
holding the line cord ! Be sure to connect the product exclusively to AC110~127V/59~60Hz!
Always onsure during installation,operation, transport and when storing the product that the mains cord is not
exposed to possible mechanical damage, or damage caused by humidity,flulds,heat or cold!
The products cable entry must not be exposed to stress from pull! Create the mains connection once the product
has been installed only .Always connect the mains plug last !
