www.flash-butrym.pl
Page 7
Never touch a lamp with bare hands! If damaged or deformed, a lamp must be
exchanged!
When exchanging the lamp be sure to use suitable lamps only. Lamps with greater
performance generate excessive heat for the product; risk of fire! Damage resulting from the
use of an unsuitable lamp is exempt from warranty!
Replace a lamp by unscrewing the fixing screws in top of the bulb compartment. Then
you open the housing. Remove the lamp by pulling it carefully out of the socket. Install a
lamp by putting it into the socket until it meets a resistance. Do not use any force – this could
cause serious damage to the socket as well as the lamp! Close the compartment and tighten
the screws.
8. Fuse
Disconnect the product from the mains before changing a fuse.
Only replace the fuse by a fuse of the same type and rating! An incorrect fuse could damage
or destruct the lighting effect.
Replace a fuse by levering the fuse holder cover with an appropriate screwdriver. Remove the
old fuse and place the fuse inside the holder. Replace the fuse holder and insert it.
9. Cleaning
The product must be freed regularly from dust, other deposits and contamination as
this may reduce the protective insulation, which may lead to a fatal electric shock!
Before cleaning, always disconnect the product from mains!
The product should be cleaned with a moist cloth only; never use aggressive cleaning agents,
solvents or benzene for cleaning.
Ensure that the product is completely dry before operating it again after cleaning!
10. Transport
To avoid damage caused during transport, wrap the product in its orginal packaging only and
handle it with great care during transport!
Technical information
Voltage: 230V AC, 50Hz
Total connected load: 700W
Lamp: 1x 300W; GY 9,5 discharge lamp
Dimensions: 470x446x650mm
Weight: 30kg
Please note: All information is subject to change without prior notice.
