Flamerite Fires Ador Installation, Precautions & Servicing Download Page 2

2 | 

P a g e

 

 

 

 

 

 

WARNING:

 In order to avoid overheating, do not cover the heater.  

 

For indoor use only. 

 

Do not use the fire in the vicinity of a bath, shower or swimming pool. 

 

Never use the fire to dry laundry. 

 

The heater must not be located immediately below a socket outlet. 

 

The use of an extension lead is not recommended. 

 

This appliance can be used by children aged from 8 years and above and persons with reduced 

physical, sensory or mental capabilities or lack of experience and knowledge if they have been given 

supervision or instruction concerning use of the appliance in a safe way and understand the hazards 

involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made 

by children without supervision. 

 

Children of less than 3 years should be kept away unless continuously supervised  

 

Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it 

has been placed or installed in its intended normal operating position and they have been given 

supervision or instruction concerning use of the appliance in a safe way and understand the hazards 

involved.  

 

Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or 

perform user maintenance.  

 

Some parts of this product can become very hot and cause burns. Particular attention must be given 

where children and vulnerable people are present  

 

Caution should be applied to ensure that children do not play with the fuel effects. 

 

As with any electrical appliance whilst the instructions aim to cover as many eventualities as possible, 

caution and common sense should be applied when operating your appliance, particularly in the 

vicinity of small children. 

 

CAUTION: 

 The heater is fitted with an automatic cut out to prevent any damage due to overheating. 

The element will continually and automatically cut out if the airflow is obstructed. 

Never

 cover the air 

outlets.  To reset, switch the fire off, disconnect from the mains supply, remove the cause of the 

overheating.  Allow to cool for a suitable period then switch the fire back on.  

 

CAUTION: 

 In order to avoid a hazard due to inadvertent resetting of the thermal cut out, the 

appliance must not be supplied through an external switching device, such as a timer, or connected to 

a circuit regularly switched on and off by a utility.    

 

 

 

 

 

 

 

Important Safety Information and Warnings

 

Where a chimney is not blocked off completely, any draw will cause the heater to cut 

out during use.  Care should also be taken when fitting into a cavity wall in case of 

damp or draft with external air vents fully sealed   

 

Summary of Contents for Ador











Reviews: