Call MENU SETUP:
Push down Key SHIFT and Key SETUP (“F”)
Call SubMenus and set values:
Toggle between Submenu selection and value selection: Push data-entry-knob
Blink Submenu ON: you select the submenu of your choise by turning the data-entryknob
Blinking OFF: you select the parameter of your choise by turning the data-entryknob
Determines the function (parameter control) of the CV-inputs USER-1 and USER-2. You can use
the booth inputs for control different parameters of the arpeggiator channels ARP and BASS.
USER-1 control ARP parameters and USER-2 control BASS parameters. Activate the values
from USER-1 with Trigger Arp and USER-2 with Trigger Bass.
Parameter:
USER-1
USER-2
Arp: GLIDE
Bass: GLIDE
Arp: NOTEREPEAT
Bass: NOTEREPEAT
Arp: SEQUENCE
Bass: SEQUENCE
Arp: CLOCK
Bass: CLOCK
Arp: GATE
Bass: GATE
Arp: VELO 1..127
Bass: VELO 1..127
Arp: VELRandom
Bass: VELRandom
Set all CV-outputs of the module in UNISONO mode
for better tuning connected oscillators.
You can set the voltage on all CV output jacks in 1 volt steps from 0 to +5volt
(note C in octave steps).
Advice: While the sequencer is run, the output setting is inactiv.
18
7. MENU SETUP
7.1 Setup USER-1/2 Inputs
TUNE-MODE
