Manual LogoTronic Hub OTC
4
1. Safety instructions
Read the instructions carefully before installation and operation.
The LogoTronic Hub OTC only works in conjunction with corresponding electronically controlled
Flamco/Meibes interface stations.
1.1 EU declaration of conformity
By affixing the CE mark to the equipment, the manufacturer declares that the LogoTronic Hub OTC
is compliant with the relevant provisions:
•
Radio Equipment Directive (RED) 2014/53/EU
•
Low Voltage Directive (LVD) 2014/35/EU
•
Electromagnetic Compatibility Directive (EMCD) 2014/30/EU
•
Restriction of hazardous substances (ROHS) 2011/65/EU.
1.1.1 General instructions
Please read!
These installation and operating instructions contain basic instructions and important information
concerning the safety, installation, commissioning, maintenance and optimal use of the equipment.
For this reason, the installer / specialist and operator of the system must thoroughly read and
observe them prior to installation, commissioning and operation of the equipment. The device is
an electric automatic control unit. This device may only be installed in dry spaces and under the
ambient conditions described in the "Technical data" section.
You must also observe the relevant accident prevention regulations, the regulations of the electrical
engineering association and your local energy supply company, the relevant DIN-EN standards and
the installation and operating instructions of any additional system components.
This device is in no way intended to replace any safety equipment that you may be required to
install!
Installation, connection to the electricity supply, commissioning and maintenance of the equipment
may be carried out only by an appropriately qualified specialist.
For the operator: You must ask the specialist to offer comprehensive training in the function and
operation of the equipment. Always keep these instructions close to the equipment.
The manufacturer will not be liable for any damage that may arise through the improper use of the
equipment or failure to follow these instructions!
1.1.2
Alterations to the equipment
•
Alterations and additions to, and conversions of, the equipment require the written consent of the
manufacturer.
•
The installation of components which have not been tested with the equipment is not permitted.
•
If it should become apparent, for example through damage to the housing, that it is no longer
possible to operate the equipment without risk, the equipment must immediately be taken out
of service.
