BlueTone
™
BTHF920
使用手册
.
10
2.
Using Seecode Vision
2.1
Battery Charging and Usage
2.1.1
Battery Charging
Seecode Vision contains a rechargeable Li-Polymer battery. First-time charging takes about 4 hours. Later-on
recharging needs 2-3 hours. The charging procedure is as follows:
1)
Plug the connector of the charger into the USB port on Seecode Vision.
2)
Connect the car charger to the cigarette lighter to start charging.
Icon indicator
will blink during the charging. When the icon changes to
, it indicates that the battery
is full and you can disconnect Seecode Vision from the power outlet.
You can also use the USB cable to charge Seecode Vision on PC. Charging by using USB cable takes longer than
by using car charger because the output power of the USB cable is smaller than that of the car charger.
2.1.2 Battery Information
Once fully charged, the battery will support continuous talk time up to 6 hours
，
standby time up to 550 hours
without connection and 280 hours with connection established.
When the battery is low, Seecode Vision beeps once every two minutes and there is a message “Battery Low”
displayed on the screen. You can charge the battery as described above.
Note that, over-charging will shorten battery life. If a fully charged battery is left unused, it will lose power over
time. Extreme temperature (either too hot or too cold) will also affect the charging ability, capacity, and lifetime of
the battery.
2.2
Mounting Seecode Vision
Seecode Vision can be easily mounted inside the car by using the accessories delivered with Seecode Vision. You
can fix Seecode Vision on the windshield, the vent in front of the driver’s seat, or any flat places in the car. With
great portability and flexibility, Seecode Vision can also be used outside of such car environment such as in office
or at home.
Note that, the microphone of
Seecode Vision
must aim at the sound bearing.
Mounting Seecode Vision on the windshield
Put the plastic cupule on the windshield and press down the locker to fix the mounting bracket firmly on the
windshield. Insert the other end of the bracket into the port on the back of Seecode Vision to connect Seecode
Vision to the bracket. To remove the bracket from the windshield, press the unlocking button which is located
between the cupule and the locker.
