BlueTone™
BTHF080 User Manual
This headset can paired with up to 8 Bluetooth equipments (including mobile handsets). The corresponding 8 sets
of pairing information are recorded in a table maintained by the headset. Each paired equipment can wireless
communicated with the headset after setting up a Bluetooth connection. Please check section 2.4.4 on procedures to
set up a Bluetooth connection.
2.4.3 Quit paring with Bluetooth Equipment
When headset in the paring mode, short press K1, it will quit from paring mode. At this time, Blue LED starts
blinking once every 3 seconds.
2.4.4 Connecting/Disconnecting your Headset with Bluetooth Equipment
When the headset communicates with a Bluetooth equipment with Handsfree Profile, the Bluetooth connection
between two equipments shall be established in advance. If two Bluetooth equipments have been paired recently,
you can simply reconnect them.
Connecting your Headset with Bluetooth Handset
：
Initiating a request from either the handsfree or the handset can set up Bluetooth connection.
Place the headset close to the Bluetooth handset:
1. Initiating connection request form the headset: Short press K1.
2. Initiating connection request form the Bluetooth handset: Follow the handset user guide to find the headset and
send connection request.
If successful, you will hear one sharp tone, and Blue LED blinks 3 times every 3 seconds; if the connection is failed,
you will hear one low tone.
Disconnecting your Headset with Bluetooth Handset:
When headset connected with Bluetooth handset, you can disconnect them as follows: Refer to handset’s manual to
initiate the disconnection from the handset side. After disconnecting, Blue LED blinks once every 3 seconds, Red
LED is off.
2.5 Call Functions
Table 1: Call Functions
2.5.1 Call
Before dialing, both your headset and handset must be power on. And you also need to ensure your headset and
handset has been linked with Bluetooth connection.
Answer Call:
Short press K1. (For the mobile handset using Headset Profile only, Long press K2 or short press K2
to receive the phone call.)
Reject Call:
Long press K2 or K1. (For the mobile handset using Headset Profile only, it has no available
functions.)
End Call:
Long press K2.
Redial:
Long press K2. (For the mobile handset using Headset Profile only, it has no available functions.)
.
9
