Flair 58 Preheat System Safety and Instruction Guide - [email protected]
Page 6
Preheat System Cleaning
Your Flair 58 Preheat system and brew head, if maintained correctly, will not require significant maintenance. For best results, all cleanings should be
completed while the brew head is affixed onto the portafilter base of the Flair 58.
Please Note: The Preheat System must be turned off and allowed ample time (at least 15 minutes) to cool before any
cleaning is attempted. Failure to allow the system to cool adequately can result in burns.
Cleaning should be completed with cool water only, and a clean damp cloth. No soaps or detergents are needed and may damage your Flair 58 and your
Preheat System. Using soap can also impact the flavor of your espresso.
WARNING: Never immerse, submerge, or fully rinse the components of the Preheat System in water. Also ensure that the
open connector points, both the four-pin and single-pin, male and female, are kept dry at all times. Failure to do this can
damage the system and will void the warranty.
To clean your Preheat System, follow these simple steps:
1. Remove plunger by pulling it out with stem while brewing cylinder is installed on base
2. Use damp cloth to wipe the inside and bottom of the brew head. Also wipe the plunger.
3. For more thorough cleaning, place a cup beneath your Flair 58 and flush with cool water before wiping. This can be repeated
multiple times to remove any coffee residue
Flair 58 & Preheat System Warranty
The Flair 58 Press Stand is warranted against functional defects for ten (10) years, from date of purchase, when used in accordance with all operating
and safety instructions. The Flair 58 metal brew head components are warranted for five (5) years, from the date of purchase, when used in accordance
with all operating and safety instructions. The electrical components of the Preheat System of the Flair 58 are warranted against functional defects for two
(2) years from the purchase date, again when used in accordance with all operating and safety instructions. Parts that are more subject to normal wear
and tear, such as O-rings, Silicone Sleeves, Piston, Tamper, Portafilter and Filter Basket are warranted against defects in material, design or workmanship
for six (6) months from the purchase date, although these items are expected to last beyond the warranty.
Proof of purchase is required to validate the warranty period.
The warranty applies only when the product and parts are used in accordance with all operating instructions. The warranty does not include shipping
costs. The warranty becomes void if we deem that the product or parts were modified, abused or improperly used, damaged by accident or neglect, or if
any parts are improperly installed.
Intact Idea makes no other warranties, express or implied, and specifically excludes warranties of merchantability and fitness for a particular purpose.
Intact Idea’s liability under this warranty shall be limited to repair or replacement of the defective part(s), whichever may apply. Intact Idea shall not be
responsible for any damages or personal injuries, whether incidental or consequential, or claims for such damages based on any legal theory, which
may occur while using this product. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state
and country to country.
