Flaem Aspira go P1611EM-20, Instructions For Use Manual

Page: 21 / 98

19
TROUBLE-SHOOTING
Switch off the device before any procedure and unplug the power cable from the socket.
PROBLEM CAUSE SOLUTION
The device does not work
- Battery flat - Charge the battery
- Battery not inserted properly - Check that the battery connec-
tor is inserted properly
- The power cable has not been
inserted properly into the device
socket or into the mains power
socket
- Correctly insert the power ca-
ble into the sockets
Lack of suction
The collection cannister lid has
not been correctly positioned on
the cannister
- Correctly position the collec-
tion cannister lid
Lid gasket not in place
- Correctly position the gasket
on the lid
Lack of suction caused by fluid
leakage
Blocked filter - Replace the filter
Blocked float Incrustation on the float
- Remove the cannister lid and
safety device and extract the
float. Continue by carrying out
the cleaning procedures as
described in the paragraph,
"CLEANING, SANITISATION,
DISINFECTION, STERILISA-
TION"
Vacuum power poor and/or
non-existent
Vacuum adjustment knob com-
pletely open
- Fully close the adjustment
knob and check the vacuum
power
Blocked protection filter - Replace the filter
Connecting tubing to the filter
and device clogged, bent or
disconnected
- Check the condition of the
tubing, replace it if blocked and
correctly connect it as per the
"ASSEMBLY DIAGRAM" of this
manual
Cannister lid overflow valve
closed or blocked - Unblock the overflow valve,
keeping the device upright
D i r t y, b l o c k e d o r d a m a g e d
pump
- Take the device to your trusted
dealer or an authorised FLAEM
service centre
If, after checking the aforementioned conditions, the device still does not work properly, we recom-
mend that you contact your local dealer or an authorised FLAEM service centre.