Fitter International Inc
.
3050 - 2600 Portland St. SE, Calgary, Alberta, Canada T2G 4M6
Ph: (403) 243-6830 Fx: (403) 229-1230 Em: [email protected]
INFLATING YOUR
DURABALL PRO
Remove the ball from its packaging. Included with the ball are two plugs.
(Adapters are only included in the Australian packaging.)
1
2
3
Once the ball is inflated to 80%, insert the plug. Let the ball stretch out for at least
a few hours, ideally overnight.
4
After the ball has been allowed to stretch at 80% inflation, remove the plug again.
Finish inflating to desired level, keeping between 80% and 100%. If you prefer the
ball to be softer, you can leave inflation at less than 100%.. Reinsert the plug and
enjoy your ball!
N
NO
OTTE
E:: N
NE
EV
VE
ER
R IIN
NFFLLA
ATTE
E TTH
HE
E B
BA
ALLLL O
OV
VE
ER
R 110000%
%
5
See other side for inflating instructions if you have a
C
Cllaassssiicc
E
Exxeerrcciissee BBaallll..
Using a tape measure, pencil and masking tape or stickey note, mark the height
of your ball on the wall (55cm, 65cm, etc.)
Metric Conversions
45cm = 18" 55cm = 21" 65cm = 25" 75cm = 29"
6
Inflate the ball to about 80% of its maximum height using a ball pump or a foot
pump, air mattress pump, etc. (Bike pumps are not recommended.)
Hold a book squarely against the wall (or use a carpenter’s square) and compare
the height of the ball with your mark. Ensure the ball is inflated to 80% of its
recommended size.
April, 2012
