FITOP M Series, Operation Manual

Page: 8 / 24

6
V
．
IMPROPER OPERATIONS
5-1. Correct Operation
5-1-1. During operation, please be sure that the wire rope is fastened at correct position
for safety; otherwise, with loosened hook, the cargo it hoisted will be fallen and
caused damage
5-1-2. Slightly loosen the tight wire rope; besides, the loose wire rope shall be tightened
steadily
5-1-3. Please make sure the wire rope has been re-organised before operating
5-1-4. Sharp angles could cause wire rope damaged; please use a smooth material to
protect the wire rope at that particular place
5-1-5. Do not impact the cargo before operating as to avoid load falls down
5-1-6. When you lift a single cargo with two hoists, please keep it well-balanced in the
centre of gravity
5-1-7. Keep the opening of hook’s wire rope within 60
°
as shown below:
5-2. Prohibitions
5-2-1. Do NOT lift weights which exceeds its allowable capacity
5-2-2. Do NOT weld a hoisted material and use the hoist to connect ground
5-2-3. Do NOT put the sheave on the ground, because the slings of the drum loosen. If the
drum reverses, will lead the wire rope reversed and fall down. The wire rope will
break down as it escapes from its correct groove
5-2-4. Do NOT load or unload when you could NOT see if there is anything on the ground
or anything between the hook and ground
5-2-5. Do NOT let the hook carries with material and keep it unloaded. It causes danger!
Kindly lift your cargo to its destiny and unload it
5-2-6. When you are lifting a material, the hook must be 2 metres above ground; the hoist
itself shall always be on the top of the material to lift
Max. 60
∘
Hook is 2 metres above
ground
2
M
The hoist itself shall be above the
material to lift up