blade increase by one step. (Counter clock wise) The
blade is positioned at “0” by default when manufactured in
factory.
The next position is “
・
” right after “0”.
!
ATTENTION
：
Do not touch the blade directly. It is very
sharp and could cause injury.
3) Tighten the blade set screw again.
After all 24 positions are used and exhausted, the blade
must be replaced by new one at cus
tomer’s expense.
Contact local service center for replacing blade service.
7.
Pinch Roller Maintenance
S326A and S326S80 has an automatic waste fiber
disposal function. To keep it operating properly, clean the
pinch roller with cotton swab soaked in alcohol after each
use. After repeated use, abrasion may form on the rubber of
the pinch roller.
However, the pinch roller keeps the function of collecting
optical fiber, as long as the depth of a groove is smaller than
the diameter of the fiber. If waste fiber cannot be removed
after cleaning the pinch roller, adjust position of the single
fiber adaptor to set it against a new spot on the pinch roller.
1) Use the attached hexagonal wrench to loosen the single
fiber adaptor set screw.
2) Hold the single fiber adaptor, and slide it towards the
lever. Let it slide for approximately 1mm, until it comes to
stop against the wall.
3) Keep the single fiber adaptor steady while tightening its
set screw.
Pinch roller replacement is required at customer expense if waste fibers cannot be removed
satisfactorily after adjusting the single fiber adaptor position. Contact our service center for
replacement inquiries.
8. Operating with ribbon fiber holder
Please remove single fiber adaptor from the main body when you use the ribbon fiber holder
(Optional parts). The fiber length from the holder edge to the cleaved fiber tip is 13mm.
9. Contacts
For sales and service information,
Contact FURUKAWA ELECTRIC CO., LTD.
Or your local representative.
Sales Department:
Furukawa Electric Co., Ltd.
2-3, Marunouchi 2Chome, Chiyoda-ku, Tokyo 100-8322 JAPAN
TEL
：
+81-3-3286-3265 FAX
：
+81-3-3286-3978
Blade set screw
Hexagonal wrench
