22
TROUBLESHOOTING
1. Probable reason for computer not workable after power start: The wire from computer to
bottom control board did not connected well or the transformer was burnt out. Check
the each wire from computer to control board, make sure they are connected well. If the
wire is destroyed , change it. If the above can not settle the problem, try to change a good
transformer.
2. E01: Message failure. Probable reason: The wires from computer and bottom control board
didn’t connect well, please check each wire. If the wire was destroyed, change a good one.
3. E02: Burst clash. Check the power is right, if not, use correct power to test; Check if the
bottom control was burnt out, change a good one; reconnect the motor wire.
4. E03，Speed sensor fault，check the bottom control, change a good one.
5. E04，Incline motor can not work: press the incline learning button in the control board for
5seconds, if it is still not workable, check if the wire is well connected or change a new incline
motor.
6. E05: Current overload protecting. Over rated loaded or the motor is stuck, cause excessive
current, machine will start self-protecting system. Adjust the machine and restart; Check if
the motor has noise from motor or if the motor / bottom control board were burnt out, if burnt
out, change good motor and bottom control; Use right voltage.
7. E06: If the motor can not work after pressing START button, the probable reason: the motor
wire is broken; the safety pipe is broken or fell; motor wire is not connected well; IGBT on
bottom control board is burnt out. Test the above reasons and change the relevant part.
TROUBLESHOOTING
Summary of Contents for TF-D1451
Page 19: ...19 EXPLODED DRAWING...
Page 24: ...24...
