Lit. No. 76454/76455/76456, Rev. 02
12
July 15, 2018
MOUNTING THE SPREADER
4. Mount the chute/de
fl
ector assembly to the spinner
assembly with supplied hardware to form the drive
assembly.
5. Mount the drive assembly to the spreader with a
bent pin and secure with a hairpin cotter. Ensure
that pin passes through the tab in the center.
6. Slide the spreader forward until the de
fl
ector/chute
assembly makes contact with the vehicle. Then
slide spreader back approximately 1" to allow
proper clearance.
7. Once the spreader is positioned front to back,
center it left to right. Looking at the inside corners
of the lower frame area, you will notice four holes
in the bottom of the frame. Using a paint pen or
similar marking device, mark hole locations.
MOUNTING THE SPREADER
NOTE: Periodically throughout the snow and ice
control season, verify that mounting devices are
secure.
1. Remove the tailgate from the UTV bed.
2. Load the spreader onto the UTV bed.
3. Mount the chute to the de
fl
ector using the supplied
hardware kit.
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie-down chains or straps
alone to hold spreader in vehicle.
CAUTION
Before lifting, verify that hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
