Lit. No. 74299, Rev. 01
6
August 15, 2020
35202
6. Remove the mount (brackets may stay installed to
the mount) and drill a 13/32" hole at each marked
location.
7. Reinstall the mount and brackets.
8. Place the driver-side upper mount bracket
between the brush guard and the frame
crossmember as shown. Align the holes in the
bracket with the holes drilled in Step 6. Secure the
upper mount bracket with two 3/8" x 1-1/2" cap
screws. Fasten with two 3/8" locknuts through
the upper mount bracket, frame, and bracket.
Install a 3/8" U-bolt over the frame crossmember
and through the bracket holes. Secure with two
3/8" locknuts.
9. Repeat on the opposite side to install the
passenger-side mount bracket.
10. Use the rear mount holes as guides to drill
13/32" holes through the vehicle frame.
11. Place a 3/8" washer on a 3/8" x 2-1/2" cap screw
and install it through the hole drilled in Step 10
and through the rear mount hole. Secure with a
3/8" locknut. Repeat for the opposite side.
Mount
Drill 13/32" holes
through vehicle
frame.
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
3/8" Locknuts
Upper Mount
Brackets
Upper
Mount
Bracket
3/8" x 1-1/2"
Cap Screws
and 3/8"
Locknuts
3/8" U-Bolt
3/8" Cap Screw,
3/8" Washer, and
3/8" Locknut
Drill 13/32" holes at
the marked locations.
