4
New headsets come with new sponges (dehydrated yellow disks) already installed in the white sponge receptacles.
The sponges will expand when submerged in water.
Snap the red and black wires onto the white sponge receptacles and then connect the other ends of the wires into the
stimulator.
Wet the sponges by submerging them under tap water or into a glass of water – you may do so while they are in the plastic
receptacles (the entire plastic sponge receptacle, including the wire, may be safely submerged in water). Squeeze out the
excess water but make sure the sponges are still wet.
Place the headband on the head so that it runs just above the eyebrows. Then place each electrode (sponges MUST be very
moist) beneath the headband just above the sideburns (see the following page).
The bottom of the electrode should be in line with the top of your ear. When both electrodes are being used on the head,
it does not matter which side the red or black wire electrode is placed. If you have thick or long hair, part the hair as much
as possible around the electrode site. The sponges and scalp must be moist for the stimulation to occur.
Now that the wet sponge electrodes are securely placed beneath the headband on your head, and the wires are connected
to the device, you are ready to turn the device on.
ASSEMBLY
Place electrode
under the headband,
above the sideburn,
on either side of head
