Note:
N
is only used for low-speed shaking. In order to prevent
containers from moving during operation, it is recommended to use rubber
bands to fasten the container.
onslip rubber mat
2. Align counter bores and nut columns, and fasten the screws.
3. Place nonslip rubber mat onto the platform.
2. Vertically clamp the tube rack into the tube rack holder and make sure the
bottom of the tube rack is closely attached to the holder.
Installation of Test Tube Rack
1. Place the test tube rack holder at the corresponding position on the
aluminum platform and fasten the 4 sunk screws.
3. Insert test tubes.
Note:
To prevent splashing, containers should not be full of liquid
during shaking. It is recommended to fill the container up to 2/3 of the
maximum capacity.
Installation of Flask Clamp and Infusion Bottle Clamp
1. Fasten flask clamp and infusion bottle clamp onto the platform with screws.
2. Put corresponding flask and infusion bottle into the clamp.
3
-
5
3
-
6
Section 3
Operation
Section 3
Operation
Fisher Scientific
Fisher Scientific
Multi Platform Shaker
Multi Platform Shaker
