The front panel contains all the controls needed to operate the unit.
TIME
①
②
③
④
⑤
⑥
This Chapter covers the control panel and its operation.
1.Start/Stop button: Start or stop the instrument.
2.RUN indicator light: The light is on when the instrument is running and
off when the instrument is in standby.
3.TIME display window: The window shows cumulative time (in continuous
mode) or remaining time (in timer mode). The range of time displayed is 0
to 99 hours and 59 minutes. The accuracy is 1 minute.
4.SPEED display window: The window shows set speed (when the instru
-ment is in standby) or current speed (when the instrument is running).
5.Set Time Buttons: UP/DOWN Arrow buttons are used to increase/
decrease the set time of the instrument.
.Set Speed Buttons: UP/DOWN Arrow buttons are used to increase/
decrease the set speed of the instrument.
6
1.Connect all the components according to the figures shown on page 1-
of this manual. Use grounded power outlet.
2.Press down the power switch on the back right side of the instrument and
put it to the “|” state and then the instrument is in standby.
3
Section 3
Operation
3.1 Operations of the Control Panel
Preparation
Section 3
Operation
3
-
1
3
-
2
3.2 Settings
Time Settings
1. Continuous mode
Press the “ ” or “ ” arrow button below the TIME display window. When
the number shown on the display window starts flashing, press “ ” arrow
button to decrease the time to 00:00 and then release the button. The time
setting is finished after the number shown on the display window has
flashed twice.
2. Timer mode
Press the “ ” or “ ” arrow button below the TIME display window. When
the number shown on the display window starts flashing, press “ ” or “ ”
arrow button to increase or decrease the time value. Release the button
when the time shown on the display window reaches the set value. The time
setting is finished after the number shown on the display window has
flashed twice.
Speed Settings
Press the “ ” or “ ” arrow button below the SPEED display window.
When the number shown on the display window starts flashing, press “ ”
or “ ” arrow button to increase or decrease the speed value. Release the
button when the speed shown on the display window reaches the set value.
The speed setting is finished after the number shown on the display window
has flashed twice.
Note:
press the “ ” or “ ” arrow buton for a longer time to accelerate
the setting.
Run and Stop
1. Continuous Mode
Press
button and the instrument will start running with the specified
settings and the RUN indicator light will be on. The TIME display window
will show the cumulative time and the SPEED display window will show the
current speed. Press “ ”button again and the instrument will slow down
until it stops. The instrument will then be in standby and the two display
windows will show the set values.
“ ”
2. Timer Mode
Fisher Scientific
Fisher Scientific
Multi Platform Shaker
Multi Platform Shaker
