Isotemp Standard Incubators
5-1
Fisher Scientific
Section 5
Operation
In Control mode operation, the incubator maintains a set temperature
until that set temperature is changed. The Actual and Set Displays will
indicate current chamber temperature and the temperature set point,
respectively. To set a temperature and initiate Control mode operation,
perform the following
1. Place the power switch in the ON position. All 8 s will flash as a test of
the display.
2. Press and hold the SET Key.
3. Observe the set temperature in the Set Display window.
4. To decrease the set temperature, press the DECREASE Key while
holding the SET Key.
5. To increase the set temperature, press the INCREASE Key while
holding the SET Key.
6. When the desired set temperature is shown, release the INCREASE
OR DECREASE Key. Finally, release the SET Key. The incubator
automatically begins to control at the set temperature.
Note
To rapidly increase or decrease the set temperature, press and hold
the appropriate key. To slowly increment or decrement the set temperature
1° at a time, press and immediately release the key.
s
Note
Upon initial heat up to temperature, the over range alarm indicator
light may illuminate briefly (several minutes) until the temperature
stabilizes at the set point. The incubator temperature should be allowed to
stabilize prior to loading samples.
s
