background image

7

1

Securing Your Child

•   Place your child in the seat. Position the restraint pad between 

your child’s legs.

•  Fasten the waist/shoulder belts to the crotch pad. Make sure you 

hear a 

“click”

 on both sides.

•  Check to be sure the restraint system is securely attached  

by pulling it away from your child. The restraint should  
remain attached.

IMPORTANT!

 The maximum weight limit for this product is 

9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but 
is really active and appears to be able to climb out of the swing, 
immediately discontinue its use.

2

•   Tighten each waist/shoulder belt so that the restraint system 

is snug against your child. Please refer to the next section for 
instructions to tighten the waist/shoulder belt.

Restraint System

3

•  To tighten the waist belts:

 Feed the anchored end of the belt up 

through the buckle to form a loop 

A

. Pull the free end of the belt 

B

Repeat this procedure to tighten the other belt.

•  To loosen the waist belts:

 Feed the free end of the belt up 

through the buckle to form a loop 

A

. Enlarge the loop by pulling 

on the end of the loop toward the buckle. Pull the anchored end 
of the belt to shorten the free end of the belt 

B

. Repeat this 

procedure to loosen the other belt.

Note:

 After adjusting the belts to fit your child, make sure you pull 

on them to be sure they are securely fastened.

LOOSEN

TIGHTEN

Free End

Waist/ 
Shoulder 
Belts

Free End

Anchored End

Anchored End

4

LOOSEN

TIGHTEN

To tighten the shoulder belts:

•  Hold the adjuster 

and pull the front shoulder strap down 

B

.

To loosen the shoulder belts:

•  Slide the adjuster down.

Adjusters

Restraint 
Pad

Summary of Contents for V4873









Reviews: