9
8
10
9
Align the holes in the handlebar assembly with the holes in
•
the post.
First, insert a #10 x ¾˝ (1,9 cm) barrel nut into a hole in the
•
post
A
. Next, insert a #10 x ¾˝ (1,9 cm) screw into the opposite
hole in the post
B
.
While holding the barrel nut in place with a Phillips screwdriver,
•
fully tighten
the screw with another Phillips screwdriver.
Replace the four #8 x 1
•
3
/
8
˝ (3,5 cm) screws into the board near
the rear wheel assembly and tighten.
Slide the rear wheel assembly onto the back of the board.
•
Hint:
Hint:
Squeeze the top and bottom
Squeeze the top and bottom
ends of the board together.
ends of the board together.
Stage 2 Assembly
Stand & Scooter Mode
Rear Wheel
Rear Wheel
Assembly
Assembly
#8 x 1
3
3
//
8
8
˝
(3,5 cm) Screws
