Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority
for recycling advice and facilities .
BATTERY INSTALLATION
1,5V x 3
“AAA” (LR03)
Required tool:
Phillips screwdriver (not included)
Access the battery compartment by unscrewing and
separating the top half of the engine from the bottom half
of the engine. Install the batteries as indicated inside the
battery compartment. Re-assemble the two halves of the
engine, re-insert the screw and tighten. If the product
begins to malfunction, check the battery installation. You
may need to reset the electronics by removing the
batteries and reinstalling them. If the product continues to
malfunction or no longer operates, remove the batteries
from the toy and replace them with fresh batteries.
Requires 3 “AAA” (LR03) batteries.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Consult the
dealer or an experienced radio/TV technician for help. NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
WHAT’S INCLUDED
WHAT’S INCLUDED
HELPFUL HINTS
HELPFUL HINTS
STORAGE
STORAGE
ASSEMBLY
ASSEMBLY
HOW TO PLAY
HOW TO PLAY
BATTERY INFORMATION
BATTERY INFORMATION
T
HOMAS’
V
OLCANO
D
ROP
T
HOMAS’
V
OLCANO
D
ROP
T
HOMAS’
V
OLCANO
D
ROP
T
HOMAS’
V
OLCANO
D
ROP
5
1
7
2
EC2
EC2
4
D3
D1
RR6
RR6
RRC
RRC
EC1
EC3
EC3
EC3
EC3
8
EC3
EC3
EC2
EC3
EC1
6
EC3
TRACK LAYOUT
TRACK LAYOUT
S2
S1
S1
CS
CS
CS
CS
CS
ES1
EC2
EC3
EC3
EC3
EC3
EC1
RS2
RS2
RR6
RR6
RRC
D1
D1
D1
RR6
TLS
BS1
EC3
X2
S2
X1
CS
X5
S1
X2
X1
EC2
X1
EC1
X1
ES1
X1
X1
D3
X2
X4
X1
X1
X2
RS2
X4
X1
X1
X1
X1
X2
X2
ADULT ASSEMBLY REQUIRED.
No tools needed.
ONE-TIME SNAPS: Assembly steps that are marked with a star are “one-time snaps ”.
Once these parts are put together, they cannot be taken apart.
S2
• Track marking codes are found on the bottom
of tracks and risers.
• Note: Some engines may not work on this track set.
• Always use the water dropper when filling the boiler. NEVER PLACE THE ENGINE
DIRECTLY UNDER THE FAUCET.
• Do not pour water or solid objects into the engine's funnel or air vent.
• Overfilling the boiler (water reservoir) may cause leakage.
• If the funnel or engine does get wet, shake the water loose and allow it
to dry before playing again. Allowing the funnel or engine to get wet
repeatedly can cause permanent damage to the toy.
• Water toys sometimes get messy. Protect play surfaces before use.
• Drain, rinse, clean and dry all items thoroughly before storing.
In order for the engine to chug with steam,
you have to fill its boiler.
Squeeze and fill the water dropper.
Note: Riser clip fits
into wider space
of track piece.
NOTE: It is best to use
COLD distilled water rather
than tap water. Tap water
can cause mineral deposits
and effect toy performance.
Never use HOT water.
1
X
X
FUNNEL
AIR VENT
Insert the water dropper into the water hole found next to the engine's funnel. Gently squeeze the water dropper slowly.
Fill the boiler a little at a time to avoid air bubbles, which could inhibit steam production. Stop filling when the boiler is
full. The engine is now ready to puff steam as it chugs along! Do NOT fill the engine’s funnel or air vent (refer to the
images provided for correct filling method). After turning the engine on, it may take some time before it starts puffing
steam. After a while, you may need to add more water to produce more steam.
WATER HOLE
2
DPM62
Based on the Railway Series by The Reverend W Awdry.
©2015 Gullane (Thomas) Limited. Thomas the Tank Engine & Friends
and Thomas & Friends are trademarks of Gullane (Thomas) Limited.
©2015 HIT Entertainment Limited. HIT and the HIT logo are trademarks
of HIT Entertainment Limited.
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
©2015 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of
Mattel, except as noted. PRINTED IN CHINA. Mattel East Asia Ltd., Room
503-09, North Tower, World Finance Centre, Harbour City, Tsimshatsui,
HK, China. Tel.: (852) 3185-6500.
1100427025-DOM
DPM62-0970
To prevent entanglement,
keep hair away from wheels.
CAUTION:
!
WARNING:
CHOKING HAZARD
– Toy contains small balls
and small parts. Not for children under 3 years.
Lift up and set the front panel of the volcano.
Flip the switch to stop the engine while you
reset the track piece inside the volcano.
Pull the tab on the back of the volcano
up to raise the track piece inside.
Place the two volcanic boulders on the platform of the volcano.
3
Press the button once to start the engine. Press it again
to stop the engine. Thomas should move forward
in the direction of the arrow.
4
Note: If the engine
runs continuously for
approximately 5 minutes, it will
automatically shut off to preserve
battery life. To resume play,
press the button on the engine.
5
STOP
GO
6
Before storage, shake the engine and drain the water from the boiler, as shown.
After using the water dropper, dry and store it in the clip on the volcano, as shown.
1
As the engine enters the volcano, it descends and causes the
volcano to erupt: the boulders fall from the side and the slab
on the front drops to reveal lava underneath.
INSTRUCTIONS
Keep these instructions for future reference
as they contain important information.
3
D3
D1
RS2
RS2
RS2
RS2
CS
D3
D3
D3
D1
D1
Item No : DPM62-0970
1100427025-DOM
Size
: 16.54" x 11.69" (A3)
Paper :
100% Recycled Paper, 70 gsm
Color
: Black
Date
: 6/5/2015 (Emma Wei)
CS
CS
Upper
side
Upper
side
Lower side
Lower side
2
1
CS
EC2
EC3
Upper
side
Lower
side
EC3
EC3
EC3
TLS
D3
RRC
D3
BS1
2
HOW TO FILL WITH WATER FOR STEAM
HOW TO FILL WITH WATER FOR STEAM
