background image

3

1,5V x 3

“AA” (LR6)

In exceptional circumstances, batteries may leak fluids that can 
cause a chemical burn injury or ruin your product. To avoid 
battery leakage:

Do not mix old and new batteries or batteries of different 

• 

types: alkaline, standard (carbon-zinc) or rechargeable 
(nickel-cadmium).
Insert batteries as indicated inside the battery compartment.

• 

Remove batteries during long periods of non-use. Always 

• 

remove exhausted batteries from the product. Dispose of 
batteries safely. Do not dispose of this product in a fire. 
The batteries inside may explode or leak.
Never short-circuit the battery terminals.

• 

Use only batteries of the same or equivalent type, 

• 

as recommended.
Do not charge non-rechargeable batteries.

• 

Remove rechargeable batteries from the product 

• 

before charging.
If removable, rechargeable batteries are used, they are only 

• 

to be charged under adult supervision

Locate the battery compartment on the bottom of the toy. 

• 

Loosen the screw in the battery compartment door and 

• 

remove the door. 
Insert three, new “AA” (LR6) 

• 

alkaline

 batteries. 

Hint: 

We recommend 

alkaline

 batteries for longer battery life. 

Replace the battery compartment door and tighten the screw. 

• 

If this product begins to operate erratically, you may need to 

• 

reset the electronics. Slide the power switch off then back on.
When sounds or lights from this toy become faint or stop, 

• 

it’s time for an adult to change the batteries. 

Protect the environment by not disposing of this product 

• 

with household waste (2002/96/EC). Check your local 
authority for recycling advice and facilities (Europe only).

Battery Installation 

Battery Safety Information

Summary of Contents for T4261









Reviews: