7
• Find the curved side (back) of the parent-assist handle.
• Find the half of the parent-assist handle grip which has
screw holes. Fit this half of the handle grip on the back side
of the handle.
• Fit the other half of the handle grip to the handle grip on the
parent-assist handle.
• Insert eight #8 x
3/
4
" screws into the handle grip and tighten
with a Phillips screwdriver. Do not over-tighten.
Parent-Assist Handle Assembly
Parent-Assist
Handle Grip
with Screw
Holes
Parent-Assist
Handle Grip
Parent-Assist Handle
Curved Side
Parent-Assist
Handle
• At an angel, insert the hooked tab on the front of the parent-
assist handle base into the slot in the back of the frame.
• Rotate the parent-assist handle down so that the small tabs
on the handle fit into the grooves in the back of the frame.
Slot
Grooves
Small
Tabs
Hooked
Tab
• Turn the frame upside down so that the parent-assist
handle rests on the floor.
• Fit the handle retainer pin into the groove in the bottom
of the frame and then into the hole in the bottom of the
parent-assist handle base.
Helpful Hint:
To align the groove in the bottom of the frame
and the hole in the bottom of the parent-assist handle, you
may need to push down on the base of the parent-assist
handle while inserting the handle retainer pin.
• Push the handle retainer pin through the parent-assist
handle base to secure the handle to the Push 'n Pedal
Trike frame.
Handle
Retainer
Pin
Hole
Groove
Seat Assembly
• Place the seat on the seat mount.
• Adjust the seat for your child’s comfort by lining up the hole
in the seat with one of the seat mount adjustment holes.
Please Note:
When the parent-assist handle is attached to
the Push n' Pedal Trike, the seat can only be secured in the
front or middle seat mount adjustment hole. When the
parent-assist handle is removed from the Push 'n Pedal
Trike, the seat can be secured in the front, middle or rear
seat mount adjustment hole.
Seat Mount
Seat Mount
Adjustment Holes
Seat
#8 x
3/
4
" Screw - 8
SHOWN ACTUAL SIZE
