4
• Slide one of the ramp cards under the top and
side tabs on the ramp.
• While slightly bending the bottom of the ramp
card, fit it under the bottom tabs on the ramp.
• Repeat this procedure to attach the other ramp
card to the other side of the ramp.
Ramp Card
• Position the ramp on the base at a slight angle,
as shown.
• Lower and “snap” the other side of the ramp to
the base.
• Pull up on the ramp to be sure it is secured to
the base.
• Insert and snap one of the handle plugs into one
of the holes in the side of the base.
• Insert and snap the other handle plug into the hole
in the other side of the base.
• While holding the loop-the-loop track together,
insert two screws into the tracks.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Ramp
Loop-the-Loop Tracks
Hole
Hole
5
4
2
3
Handle
Base
Plug
Hole
Hole
Base
Bottom Tabs
Top Tabs
Side Tabs
