15
Problem
Cause
Solution
No bubbles
Not enough bubble solution in
bubble chamber
Press down on bubble solution
bottle for 15 seconds to refi ll.
Bubble chamber is clogged
and dirty
Follow instructions in “Let’s
Clean Up” section to clean bubble
chamber thoroughly.
You have not walked far enough
to produce bubbles
The bubble mower needs to be
pushed a minimum of 15-20
walking steps before bubbles
begin to fl ow.
You are walking too quickly
Walk at a slow, steady pace.
The rear wheels do not contact
the ground
Push the mower so that the
rear wheels always contact
the ground.
Silicone or oily lubricants
may have gotten in the
bubble chamber
Never use silicone or oily
lubricants on this product (the
wheels). Bubbles will not form
if even a very small amount of
these substances get into the
bubble chamber.
Bubble solution is leaking from
the mower
Bubble chamber over-fi lled
Fill only by using fi ller cap. The
fi ller cap dispenses the correct
amount of solution.
The mower is used on an
inclined surface
Use the mower only on fl at,
level ground.
Bubble solution is foaming
Bubble chamber is clogged
Follow instructions in "Let's Clean
Up" section to clean bubble cham-
ber thoroughly.
G
Problems and Solutions
