Setup & Use
IMPORTANT!
Test sound reception of this monitor before first
time use and whenever you change location of transmitter
(see page 4).
1.
Set transmitter channel switch to same channel as receiver.
2.
Place transmitter in same room with child. Point micro-
phone directly toward crib or play area.
3.
Unwrap and fully extend power cord for best transmission.
Insert power cord plug into wall outlet.
4.
Rotate transmitter power/volume dial to turn power on.
Power indicator lights.
5.
If you’d like baby to enjoy sounds or music, slide the
sound switch
to:
Location: Transmitter (TX) BUTTON front
music;
sound effects or
O
off.
Press the start button. Sounds turn on
gradually
to the
volume selected.
6.
If you’d like to entertain baby with a ceiling light show, slide
the
light switch
to . Press the start button. Lights turn on
gradually
. To turn the ceiling light show off, slide the light
switch to
O
.
7.
You can adjust where the ceiling light show projects and the
image clarity. Rotate the transmitter on the base to project
the light show over baby's crib. Now, rotate the lens to focus
the image.
8.
Rotate power/volume dial to adjust volume.
9.
If you would like the light show/music or sound effects to
automatically turn on when baby fusses or cries, rotate the
sound sensor dial
on. Now, adjust the sensitivity for
baby’s sounds. Rotate towards for high sensitivity (shallow
sounds); rotate towards for low sensitivity (loud sounds).
To turn this automatic feature "off", rotate the sound sensor
to
O
off.
Hint:
You may want to start with the high sensitivity
setting at first.
10.
Press the
start button
. Light show/music or sound effects
will
gradually
turn on for about 10 minutes and then
automatically turn off. If you’d like to turn off lights/music/
sound effects, press the start button on the transmitter.
Lights/music/sound effects
gradually
turn off.
11.
Place receiver where you will see or hear it.
12.
Unwrap and fully extend AC adaptor cord for best reception.
Insert AC adaptor jack into receiver socket and plug into
wall outlet.
Note: To use LR6 (AA) alkaline batteries for power source, refer
to "Receiver Battery Installation" instructions on page 3.
13.
Rotate receiver power/volume dial to turn power on.
Power indicator lights. Rotate power/volume dial to
adjust volume.
1
11
1
6
