6
Elevator Tower
Side Support
Legs
Connector
Tube
Tower
Roof
Base
• Remove the instructional labels from the base and discard
them.
• Position the ramp assembly over the base. Make sure the
elevator tower, side support legs, and connector tube align with
the recesses on the base, as shown.
• Push down
firmly
on the tower roof to snap the elevator tower
into the base.
• Push down
firmly
on the top of each side support leg to snap
the side support into the base.
• Pull up on the elevator tower and top floor to make sure the
ramp assembly is secured to the base.
Spiral
Ramp
Push Here
Spiral
Ramp
• Push down firmly at the base of the upper spiral ramp to snap it
into the center floor.
• Push down firmly at the base of the lower spiral ramp to snap it
into the base.
Helpful Hint:
You will hear a “click” when each tab on the
spiral ramps snaps into the center floor or base.
• Pull up on each spiral ramp to make sure it is secured to the
garage floor.
Tabs
Hill Track
Top Floor
Elevator
Tower
Tabs
Slots
• Position the speed ramp so that the underside is facing you.
• Insert the jump lever up through the slot in the speed ramp, as
shown .
• Turn the speed ramp so that the top faces you.
• Insert the pin on the end of the jump lever into the hole in the
speed ramp
.
16B
16A
Jump
Lever
Jump
Lever
Hole
Pin
Slot
Speed Ramp
• Insert and firmly snap the tabs on the top of the hill track into
the slots in the elevator tower. You will hear a “click” when each
tab snaps into the elevator tower.
• Insert and firmly snap the tabs at the bottom of the hill ramp
into the slots in the top floor. You will hear a “click” when each
tab snaps into the top floor.
• Pull up on the hill track to make sure it is secured to the
elevator tower and the top floor.
• Insert the pins on the sides of the speed jump into the holes in
the sides of the speed ramp.
Pin
Pin
Hole
Hole
Speed Jump
Speed Ramp
14
15
16A
16B
17
13