4
• Position the side support on a flat surface.
• Insert four
3
/
4
" screws into the side support. Tighten the screws
with a Phillips screwdriver. Do not over-tighten.
• Fit the square openings on the underside of the top floor onto
the posts on the side support.
• Make sure the rectangular tab on the top floor inserts into the
rectangular opening on the side support upper crossbar.
• Push down
firmly
on the top floor to snap it onto the side
support.
Helpful Hint:
You may need to push down near each of the posts
and the tab to fully snap each one into the side support. You will
hear a “click” when each post and the tab snaps into the side
support.
• Pull up on the top floor to make sure it is secured to the side
support.
Top Floor
Side
Support
Leg
Opening
Middle
Tab
Lower
Crossbar
Center Floor
End Tab
End Tab
Square Opening
Square Opening
Post
Post
Side
Support
Upper
Crossbar
Rectangular
Opening
Rectangular
Tab
Side Support
3
/
4
" Screws
3
/
4
" Screws
Opening
Opening
• Insert the middle tab on the center floor into the opening in the
side support lower crossbar.
• Insert the end tabs on the center floor into the openings in the
side support legs.
• Push down
firmly
on the center floor to snap it into the side
support.
Helpful Hint:
You may need to push down near each of the three
tabs to snap each one into the side support. You will hear a
“click” when each tab snaps into the side support.
• Pull up on the center floor to make sure it is secured to the side
support.
• Set the side support assembly aside.
5
7
6
• Place the elevator tower with the rails on a flat surface, with the
rails facing up.
• Place the other elevator tower on the flat surface, as shown.
• Insert two 1" screws into each elevator tower, as shown.
Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• With the elevator at an angle, fit the grooves in the elevator
onto the rails at the bottom of the elevator tower
.
• Rotate the elevator down
to fully seat the
grooves onto the elevator tower rails.
• Slide the elevator to the middle of the elevator tower
.
3
2
1
Bottom of
Elevator
Tower
Elevator
Rails
1" Screws
Elevator
Towers
1
2
3
1" Screws
8