10
6
8
7
DISCARD PACKAGING RESPONSIBLY
REMOVING THE DRAWER (OPTIONAL)
CONNECT THE WARMING DRAWER TO THE MAINS SUPPLY
Recycle responsibly
Unpack the warming drawer and inspect for any signs of damage. Do not
install the warming drawer if it has been damaged.
Important!
Packing materials (e.g. plastic bags, polystyrene foam, staples, packing straps
etc) and tools should not be left around during and after installation,
especially if they are within easy reach of children, as they may cause serious
injuries.
Important!
All electrical work may only be carried out by suitably qualified and competent
persons in accordance with national and local safety regulations.
This warming drawer must be earthed.
Before placing the warming drawer into the cavity, route the power cord
into the back of the cavity and plug it in to the switched socket. The
switched socket should be in an easily accessible area within 900 mm of
the centre rear of the product.
Power requirements
Model
Code
Power
Voltage
Wattage
WB60SD
1.6 - 1.8 A
220-240 V
360-420W
5
You can remove the drawer to aid the installation process. Removing the drawer allows
you to pre-drill the holes through the front trim for the securing screws.
1
Ensure the warming drawer is switched off.
2
Open the drawer to its fullest extent (ensure the drawer is empty).
3
Using a small Phillips-head screwdriver undo the screws located on the drawer sides
(one on each side).
4
Carefully pull the drawer forward until clear of the tabs at the back of each telescopic
slide.
5
Lift the drawer off the telescopic slides.
Replacing the drawer
1
Extend the slides out.
2
Place the drawer over the outer ends of the telescopic slides.
3
One at a time, pull the telescopic slides forward until the screw holes in the slide and
drawer align.
4
Replace the screws.
2
2
1
3
