FISHER & PAYKEL TRADITIONAL MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Installing Trim Kit
1.
Cut opening in the cabinet face per the following dimensions:
Height: 17” + 1/16”, –0
Width: 24-3/4” + 1/16”, –0
Note:
Refer to diagram on the following page. The minimum
cabinet depth is 20”. When installing the Microwave and
Trim Kit in combination with a Wall Oven or Warming
Drawer, please follow the recommendations in the
Microwave Installation/ Use & Care Manual.
2.
Add adequate platform base support in the bottom of the
cabinet for trim kit base to rest on.
3.
Mark a centerline on the front edge of the cabinet bottom
(Fig. 01).
4.
Place trim kit base and align centerline mark to the triangular
notch on the front edge of the base (Fig. 02).
5.
Drill 1/8” pilot holes in the cabinet using the base as a
template and install a screw through the base into the cabinet
bottom to prevent the base from shifting (Fig. 03).
6. Insert Microwave into opening on top of the base. The
Microwave feet should sit in the recesses on the base for
correct alignment. The Microwave should be plugged in at
this point.
Before you begin, read these instructions completely and carefully.
Getting Started
■
Remove packaging
Contents
Tools Required
Part Description
Qty
Trim Assembly
1
Base
1
Mounting Bracket (L/R)
2
Sheet Metal Screws
10
Fig. 01
Fig. 02
Fig. 03
1/8” Drill
#2 Phillip Screwdriver
Summary of Contents for Traditional Microwave trim kit
Page 4: ...P N 242601 Rev B 06 14 ...
