13
Pic 7
Pic 8
Pic 9
12. Fix the expansion pipe to the outlet with a cable tie See
8. Connect
the power supply.
13. Check that hood is secure. Lift the outside chimney off the hook and slide it
down over the hood. See pic 9.
Recirculation Installation only
‐
‐
Install the recirculation T-shaped plastic outlet
1.
As shown in ic 10, drill two 8mm holes, 45mm apart centered on the hanging
board. Use 2x ST4*30mm screws to attach bracket 2 onto the ceiling. Use the
wall plugs if required.
2.
As shown in
12, use 2 pcs ST4*8mm screws to fix bracket 1 to the T-shaped
plastic outlet.
3.
Adjust the width of the T-shaped outlet to the width of the chimney. Secure this
position with 2pcs ST3*12mm screws.
4.
As shown in pic 13 and 14, fix the T-shaped plastic outlet to the ceiling with 2 pcs
ST4*8mm screws.
5.
Complete the rest of the installation as per vented installation. As shown in pic 15
and 16, use 4pcs ST4*8mm screws to fix the inside chimney to the hanging board .
INSTALLATION INSTRUCTIONS
p
pic
pic
(Accessory available)
Summary of Contents for HI90BLX1
Page 1: ...INSTALLATION INSTRUCTIONS USER GUIDE HI90BLX1 ISLAND RANGEHOOD BOX CHIMNEY NZ AU ...
Page 2: ......
Page 4: ......
