Fisher & Paykel FabricSmart WA1068P, Installation Instructions And User Manual

Page: 10 / 48

8
INSTALLATION INSTRUCTIONS
Inlet hoses
ImpORTANT!
● ●
New hose sets provided with the washer shall be used to connect the washer to the
water mains.
● ●
Old hose sets should not be re-used.
1
Connect the straight ends of the inlet hoses to the taps
(there are washers fitted in both ends). Connect the red
connector hose to Hot, and the white connector hose to Cold.
2
Connect the elbow ends of the inlet hoses to the
corresponding machine inlet valves. Inlet valves are marked
on the back of the machine. Ensure the Hot valve is
connected to the hot tap and the Cold valve is connected to
the cold tap.
H = Hot C = Cold
Cold supply only:
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be
connected to the Hot inlet valve. The cap prevents water leaking out of the hot
valve. The cap is available from your Fisher & Paykel dealer or Authorised Repairer,
Part No. 388491P. This appliance incorporates backflow protection complying with
AS3500.1. No further backflow protection is required for connection to the water supply.
Note: your washer does not have an internal heater to heat water.
Inlet hose replacement
We recommend replacing the inlet hoses every 5 years. Hoses should be checked from
time to time and replaced if any wear, cuts, bulges, kinks or leaks are found.
WARNING!
Failure to do so may result in a flood and damage to property.
Elbow
(Machine) end
Straight
(Tap) end
Inlet hose ends