Fisher & Paykel DW24U2I1, Installation Manual, Page: 14 / 23

12
1
Fix slider bracket and screws to custom panel
Insert Ø3.9 x 1/2” (13mm) screws through the top two
pilot holes. Fix the slider bracket to the panel through
the lower pilot holes.
4
Balance the door
Check the door balance by opening and closing
the door. If the door drops when released,
increase the tension. If the door rises when
released, decrease the tension.
5
Secure the custom panel
Open the door and remove the
four screws and replace with
Ø3.9 x 1 1/2” (38mm) screws to
fix the panel into place.
2
Hang custom panel onto the door
Close the door of the dishwasher and align the screws
and the bracket on the custom panel to the front of the
dishwasher door.
3
Adust the placement of the custom panel
Slide the custom panel up or down to position it in the
desired location.
Top screw detail
(between panel and screw head)
Screw locations
(repeat on both side of appliance)
Increase
Decrease
3mm
!2 ATTACHING CUSTOM DOOR PANEL