Fisher & Paykel DW24U2I1, Installation Manual, Page: 13 / 23

11
[B] MANUALLY MARK AND DRILL PILOT HOLES
If the template is not available, mark the pilot holes manually on your custom panel based on
measurements in the below table. Ensure pilot holes are 1/16” (2mm) wide and 1/2” (12mm) deep.
If overhang is between 1 5/16” (34mm) and 2 1/8” (54mm):
PANEL A MEASUREMENTS in (mm)
A
Base of panel to lower bracket hole
4 1/16 (103)
B
Base of panel to upper bracket hole 4 7/8 (124)
C
Base of panel to handle holes 18 9/16 (472)
d
Centre line to handle holes 9 1/4 (235)
If overhang is between 2 1/8” (54mm) and 2 15/16” (74mm):
PANEL B MEASUREMENTS in (mm)
A
Base of panel to lower bracket hole
4 13/16 (123)
B
Base of panel to upper bracket hole 5 11/16 (144)
C
Base of panel to handle holes 19 3/8 (492)
d
Centre line to handle holes 9 1/4 (235)
Note: measurements are to center of holes.
Measure the panel and overhang
Measure the custom panel and check the overhang length
from the base of the door.
!1 CUSTOM DOOR PANEL PREPARATION
Upper overhang detail
(when using an infill bracket)
Lower overhang detail
(all custom panel installations)
IMPORTANT!
z
z
Ensure the custom door panel has the correct specifications
to fit the front of the dishwasher.
z
z
Ensure the back and sides of the panel are completely sealed
with a waterproof vapor barrier (ie polyurethane). The barrier
allows the panel to withstand moisture (122°F ( 50°C) @ 80% RH)
and prevent damage during hot and wet environment.
[A] DRILL PILOT HOLES USING SUPPLIED TEMPLATE
Using the supplied Door Panel Template, mark out and drill the required pilot holes
into your custom panel. Ensure pilot holes are 1/16” (2mm) wide and 1/2” (12mm) deep.
Utilisez ce gabarit pour percer avec précision les avant-trous destinés à la fixation
de votre panneau de porte encastré.
Déterminez la hauteur de porte appropriée ci-dessous et alignez le gabarit avec la base
de votre panneau de porte. Pour les instructions d’installation complètes, reportez-vous
au Guide d’installation fourni avec votre appareil.
Pilot holes
Centre line
Avant-trous
Ligne centrale
Use this template to accurately drill the required pilot holes in your custom door panel.
Establish the appropriate dimension below and align the template with the base of your panel.
For full installation guidance, refer to the Installation Guide supplied with your appliance.
DOOR PANEL TEMPLATE GABARIT DE PANNEAU DE PORTE
Door overhang: 2 1/8" – 2 15/16" (54mm – 74mm)
Door overhang: 1 5/16" – 2 1/8" (34mm – 54mm)
Partie saillante de la porte : 2 1/8 po – 2 15/16 po (54 mm – 74 mm)
Partie saillante de la porte : 1 5/16 po – 2 1/8 po (34 mm – 54 mm)
591518B 05.19 591518B 05.19
D D
C
B
a
1 5/16 – 2 15/16”
(34-74mm)