READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY.
BADGE AND HANDLE POSITIONS
On both Panel, select the Badge position to suit the cabinetry design,
within the available badge zone.
If required, the Badge may be centered on the edge of the badge zone.
The handle position will also need to be taken into account.
PANEL PREPARATION INSTRUCTIONS
STEP 1:
BADGE AND HANDLE POSITION
STEP 2:
BADGE CUT-OUT & BRACKET REMOVAL
BADGE CUT-OUT
Cut the badge slot in the Panel by drilling two 1” (25.4mm) diameter holes
and cutting out the remaining material between the holes. A hole center
to hole center template is provided on the Mounting Backet.
WARNING!
Be sure the Product is not plugged in.
Important!
Accuracy is essential when cutting the Badge slot to ensure a neat fit
to hold the Badge.
REMOVING THE BRACKET
1)
To remove the Mounting Bracket withdraw the pins from the Drawer
sides, using a pair of needle-nose pliers.
2)
Gently slide the Mounting Bracket off in a downwards and outwards
motion. Disconnect the Mounting Bracket and Badge grounding
wires, also unplug the Badge harness from the Badge Isolator box.
Remove the Badge from the Mounting Bracket.
NOTE: The four
1
/
8
”
(3.3mm) holes on the perimeter of the
rectangular recess in the Mounting Bracket can also be used
to define the badge zone.
3
(Not shown to scale)
