Fisher & Paykel DH9060P, Installation Manual/User Manual

Page: 27 / 40

25
User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that
you can correct yourself. To stop the beeps sounding, touch any button on the
control panel. Do not try to continue your drying cycle once you stop the noise.
You must address the problem the dryer is alerting you to. Check the below table
before you call for service.
PROBLEM WARNING WHAT TO DO
Keylock is
activated
Touch and hold the ‘Keylock’ button for 3 seconds
to deactivate the Keylock.
Clean evaporator
grid
Refer to page 23 ‘Cleaning the condenser filter
and evaporator grid’.
Clean condenser
filter
Refer to “Cleaning the condenser filter and
evaporator grid” on page 23 ‘Cleaning the
condenser filter and evaporator grid’.
The lint filter
is blocked and
needs to be
emptied
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter
holder which may be blocking the air flow.
Check the lint filter is in place correctly in
your dryer.
Clean the condenser filter, refer to the ‘Caring for
your dryer’ section). Ensure the condenser filter
unit has been placed or replaced correctly into
your dryer.
The water tank
is full and needs
to be emptied
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water
tank or drain hose is blocked.
Check the drain hose is still attached at the back
of the machine, and is not kinked or squashed.
BEFORE YOU CALL FOR SERVICE