13
INSTALLATION INSTRUCTIONS
Before a rear venting option is installed the dryer must be changed from the front
venting factory setup. Remove the outlet grille from the front left-hand side and replace
with the outlet cover from the rear left-hand side. These covers should be gently pried
at the sides to prevent damage.
External venting options
●
●
The dryer can be vented with a kit that can be
positioned to vent upwards or to the side. Kit part
number PD-DK4W.
●
●
The dryer can be vented directly through the wall with
Kit part number PD-SVHCW4, in combination with the
duct adaptor supplied with the dryer.
Note: the vent system should be a maximum of 2 metres
with no more than three 90⁰ bends.
Internal venting
Front venting is the only option for internal venting.
The dryer is set up for front venting when it leaves
the factory.
Note: all efforts should be made to vent the dryer
externally, if possible, to avoid moisture build up in the
area around the dryer.
Electrical connection
1
This appliance must be connected to a
220 V – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
2
Uncoil the power cord, remove and discard the plastic pin
cover and plug into a power socket.
3
Connect the appliance to an earthed outlet protected by a
fuse of suitable capacity.
●
●
Check the power cord for damage and make sure it is not
squashed or twisted when installing the dryer.
●
●
Always remove the power cord from the power socket by
the plug, not by the cord.
IMPORTANT!
●
●
Do not touch or operate the dryer with wet hands or with bare-feet.
●
●
A damaged power cord must be replaced by a Fisher & Paykel Authorised Repairer.
The appliance must not be operated until it is repaired, as there is risk of electric shock.
●
●
Do not operate this dryer if it has been damaged during transport. Contact your
Fisher & Paykel dealer or Fisher & Paykel Authorised Repairer.
Through-wall
mounted ducting
Wall mounting ducting
