17
INSTALLATION INSTRUCTIONS
Completing the installation
Installation test cycle
IMPORTANT!
Ensure the installation test cycle is completed before you dry any items in your dryer.
This is to check that your dryer is installed correctly and that it is functioning properly
prior to use.
1
Turn your dryer on by pressing the ‘POWER’ button.
2
Select the ‘Time Dry’ (30 mins) cycle. Ensure the drum is empty and the door is closed
(you will hear it click shut).
3
Touch the button. The drum will start rotating.
●
●
Observe the machine for any problems.
●
●
The dryer will beep and display any faults on the screen if there are any problems.
Refer to pages 28 and 29.
4
At the completion of the cycle open the door and check that there is warmth inside the
dryer. This indicates the dryer is operating normally.
IMPORTANT!
If there are any problems, you must address these before proceeding with normal use.
The dryer will automatically turn off at the end of the cycle if there are no problems.
Before you start, it is a good idea to go through the following checklist:
1
Has the packaging been removed?
2
Is the machine correctly levelled, and the cabinet corners clear of the floor and walls?
3
Are the water tank, condenser and lint filter correctly in place?
4
Has the power cord been connected to an appropriate power supply and the power
turned on?
5
Have you performed the installation test cycle?
6
If external draining is preferred, is the drain hose attached to the correct outlet and
hooked into a standpipe or tub?
EN
