14
US
CA
Problem
Possible Cause
Remedy
Appliance not cold enough
(See “Adjusting the tempera-
ture" on page 10)
• Control set too warm
• Content temperature not stabilized.
• Excessive usage or prolonged drawer
openings.
• Airflow to front grille blocked.
• Drawer gasket not sealing properly.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours.
• Airflow must not be obstructed to front
grille. See “clearances” on page 4.
• Adjust or replace drawer gasket.
Appliance too cold
(See “Adjusting the Tempera-
ture” on page 10)
• Control set too cold
• Drawer gasket not sealing properly.
• Adjust temperature warmer.
Allow 24 hours for temperature to stabilize.
• Adjust or replace drawer gasket.
No interior light.
• Failed LED light assembly or light switch. • Contact a qualified service technician.
Light will not go out when
drawer is closed
• Drawer not activating light switch.
• Failed light switch
• Appliance not level, level appliance,
(See page 4, “leveling legs”)
• Contact a qualified service technician.
Noise or Vibration
• Appliance not level
• Fan hitting tube obstruction.
• Level appliance, see “Leveling Legs” on
page 4.
• Contact a qualified service technician.
Appliance will not run.
• Appliance turned off
• Power cord not plugged in.
• No power at outlet.
• Turn appliance on. See “Starting your
appliance” on page 10.
• Plug in power cord.
• Check house circuit.
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
!
WARNING
Electrocution Hazard
Before You Call for Service
If the appliance appears to be malfunctioning, read through
this manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
TROUBLESHOOTING
