Fisher & Paykel DCS DishDrawer DD24DUT7, User Manual

Page: 25 / 68

21
Troubleshooting
Problem Possible cause What to do
Drawer will not
open (no beeping,
no wash underway) Childlock feature is on or
the ‘Closed drawer autolock’
option is on, or both. Turn the Childlock off. Hold down the
button until the light above the
button goes out and/or press the button
to open the drawer.
Power failure
during cycle Power outage in your home
or area. Wait until power resumes, cycle will restart in
same part of wash program.
Continuous
beeping A fault has occurred. Refer to section ‘If there is a fault’.
Intermittent
beeping Dishwasher is in pause
mode.
Close the dishwasher and press the
button to resume the program.
High-pitched,
subtle beeping
during a wash
program Rinse aid is being
dispensed. This is normal and needs no action.
Control buttons
inside the drawer
do not respond to
touch Water over control buttons. Wipe the area dry.
Dishwasher will not
start Power supply is not
connected. Connect the power supply.
The drawer is not closed
properly. Ensure the drawer is firmly closed.
Keylock or Childlock feature
is on. Turn the Keylock or Childlock off. Hold down
the button until the light above the
button goes out.
button not pressed. Press the button.
Fan noise
coming from the
dishwasher after a
wash program has
finished This is normal. The drying
fan continues to run for a
set period of time after a
program has finished to
assist with drying. No action required. The fan will automatically
stop after the set time is over, or when the
drawer is opened. In some cases, the fan may
resume when the drawer is closed again.
Fan noise starts
up when I close
the drawer, even
though I didn’t start
a new wash This is normal. In some
cases, the drying fan will
run whenever the drawer is
closed for a set period of
time after a program has
finished. No action required. The fan will automatically
stop after the set time is over.
US
CA