1. Connect the straight ends of the inlet hoses to the
taps (there are washers fitted in both ends). Connect
the red connector hose to hot, and white connector
hose to cold (if your hoses are colour-coded).
2. Connect the elbow ends of the inlet hoses to the
machine inlet valves. Inlet valves are marked on the
back of the machine. Ensure the hot valve is
connected to the hot tap and the cold valve is
connected to the cold tap.
Fig. 3 Inlet hose ends
Inlet hose replacement
The inlet hoses should be replaced every 5 years. Hoses should be checked from time to time and replaced if any
wear, cuts, bulges, kinks or leaks are found.
Electrical
This appliance must be supplied with a 220 V – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
Leveling Instructions
It is IMPORTANT to level the machine to ensure good spin performance and effective
detergent and fabric softener dispensing.
A spirit level is provided with your machine. Use this to level your machine, always placing it on a clean, flat surface. The
machine is level when the bubble sits in the centre, within the two lines.
Your washer is equipped with self-locking feet to ensure they do not move once you have levelled your machine. To
adjust the feet, pull down then twist to move them up or down.
Updated: Sat, 16 Nov 2019 03:22:08 GMT
Powered by
4
