Fisher & Paykel CG604DW, Installation Instructions And User Manual

Page: 12 / 60

10
EN
Installation instructions
Special requirements for CG604 and CG905DWFC models
Gas connection to these cooktops MUST use the elbow supplied. The regulator will not seal if
installed without it.
Ensure the fibre washer (supplied) is located between the elbow (supplied) and cooktop gas
inlet (Fig.2). Failure to use this washer will cause the connection to leak. Tighten the floating
nut to firm finger tight, plus an additional ¼ turn (90
o
).
Gas connection with a flexible hose
If the gas is connected with a flexible hose, the connector on the wall should be between 800-
850 mm above the floor and to a distance of at least 250 mm outside the width of the cooktop.
The connector should be accessible with the cooktop installed.
Flexible hose assemblies should be certified. The thread connection shall be Rp ½” (ISO 7-1)
female. See Fig. 2.
The hose assembly must be as short as practicable and comply with relevant requirements.
The hose must not be kinked, subjected to abrasion or permanently deformed.
The hose must not be near or in contact with any hot surfaces (eg base of metal hotplate, flue or
chassis of underbench oven etc).
Fibre washer
Elbow (
1
/
2
” BSP external thread)
Fig.2 Gas connection to the cooktop
(CG604 and CG905DWFC models)