5
Installation instructions
Levelling your machine
It is IMPORTANT to level the machine to
ensure good spin performance and effective
detergent and fabric softener dispensing.
1
Separate the 4 rubber foot inserts from the
moulding and fit into the feet on the base
of the machine.
2
Move the machine to its final position
(we suggest a minimum clearance of 20 mm
each side).
3
Adjust the feet (wind down) so the machine
does not sit on the corner cabinets (these
must be clear of the floor). Adjust so that
the machine is level and does not rock.
4
To check levelling, open the lid.
5
At the front of the machine, slide the end of a
tape measure between the topdeck and the neck
ring, until it touches the inside front of the main
cabinet (Fig.6). Accurately measure the distance
from the inside of the cabinet to the inner most
edge of the neck ring.
6
If the machine is correctly level, this distance is:
90 ± 2 mm (600 mm wide, 7 kg capacity machine)
95 ± 2 mm (650 mm wide, 8 kg capacity machine)
7
Repeat process for the left side of the machine
(Fig.7). Ensure you measure the correct distance
for the size of machine you have.
8
If the measurement is incorrect, adjust the
feet (by winding them up and/or down) until
you achieve the correct measurement at both
locations. Ensure after every adjustment that the
machine does not rock.
9
Turn on the water and check all hose connections
for leaks. Make sure there are no kinks in
the hoses.
10
Uncoil power cord, remove and discard
the plastic pin cover, and plug into
wall socket.
Fig.5 Adjusting levelling feet
Rubber insert
Adjustable feet
Corner cabinets
80 80 90 100 110 120 130 140 150 160 170 180 190
220 230 240 250 260 270 280 290
200 210
80
80
90
100
110
120
130
140
150
160
170
180
190
220
230
240
250
260
270
280
290
200
210
Neck ring
Measure here
Top deck
Fig.6 Measure at the front of the machine
Fig.7 Measure at the left side of the machine
80 80 90 100 110 120 130 140 150 160 170 180 190
220 230 240 250 260 270 280 290
200 210
Note:
Measurements for the different models:
90 ± 2 (600 mm wide, 7 kg capacity machine)
95 ± 2 (650 mm wide, 8 kg capacity machine)
Ensure you measure correctly for the size of
machine you have.