3
Installation instructions
Unpacking
To ensure the best performance from your new
AquaSmart 2™
clothes washer please follow the instructions below.
Removing the packaging
1
Remove the outer packaging.
2
Tilt the machine backwards and walk it off the bottom
packer one foot at a time.
3
Remove the bottom packer from under the machine
by pulling it out the front.
4
Lift the lid and remove the bowl packer from the bowl.
5
Remove the hoses and accessories.
6
Keep the bottom packer and bowl packer in case they
are required for future transit.
Important!
Ensure that the bottom packer has been removed before operating your machine.
Installation
Your washer must be installed on a level surface, and
not on any textured floor coverings (eg carpet, rugs) to
ensure that the opening at the bottom of the machine
is not obstructed.
In your clothes washer you will find:
4 rubber inserts for the levelling feet (joined together).
1 hose guide.
2 inlet hoses.
Drain hose
1
Carefully pull the drain hose out from the back of the
machine by pulling the exposed part of the hose downwards and outwards.
2
To guide the drain hose over the tub or standpipe the hose guide MUST be fitted to the drain hose.
Important!
To prevent siphoning the drain hose should not extend more than 20 mm from the end of the
guide. The height of the standpipe or tub should be between 850 – 2400 mm. The drain hose can
be trimmed to length.
3
Place the drain hose in the tub or standpipe.
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions which may
affect how your machine works or may cause flooding.
In multi-storey apartments, or any upper floor, the machine should be installed on a floor that is
equipped with a drain.
Draining must comply with local by-laws.
Fig.2 Tilt washer backwards
to remove packer
Pull hose
through
guide
Flex hose
guide apart
Standpipe
850
–
2400
mm
(20 mm)
maximum
Fig.3 Fitting the drain hose guide