19
INSTALLATION INSTRUCTIONS
IMPORTANT!
●
●
All connections must be checked for leaks.
●
●
Ensure 6mm tubing is routed away from sharp objects,
sharp corners (beware of kinking the tube as this will stop
water flow), clear of the refrigerator rear compartment and
not in a location where it can be kinked or squashed.
●
●
Ensure all push-fit connections are firmly pushed into place.
The tube should push in 16mm before reaching the stop.
●
●
If tubing is removed at any point, re-cut the end and
re-insert. Tubing must be fully inserted to avoid leaks.
●
●
To remove tube from connection points first turn off the
isolating faucet. Gently push the dispensing pad a few
times using a glass or container to remove the static line
pressure. Push in the collet firmly while pulling back on the
tubing at the same time, as shown in Diagram 11.
847200 - Certified by: IAPMO R&T against NSF/ANSI Standards 43, 53, 401 and CSA
B4831.1 for the reduction of claims specified on the performance data sheet and at
iapmort.org. 847200 compounds certified under NSF/ANSI 401 have been deemed
as incidental contaminants/emerging compounds. Incidental contaminants are those
compounds that have been detected in drinking water supplies at trace levels. While
occurring at only trace levels, these compounds can affect the public acceptance of
drinking quality water.”
847201 - Certified by: IAPMO R&T against NSF/ANSI Standards 43 and CSA B4831.1 for
the reduction of claims specified on the performance data sheet and at iapmort.org.
Rated capacity:
847200 – 102 gallons (386 litres)
847201 – 170 gallons (643.5 litres)
Diagram 11
