8
INSTALLATION
Before you begin
z
Check cavity dimensions are correct for the type of dual installation you require.
z
Unpack appliances from packaging following guidance on individual cartons.
z
Ensure the floor is protected from damage during unpacking and installation.
z
Check that the Joiner Kit is complete.
z
Always position the two appliances side-by-side with the door hinges on the far left and
right, ensuring you have enough space to access the rear of the appliances.
1
Remove the rear compartment cover
using a Phillips screwdriver. This will be
re-attached later.
2
Remove the screw on the filter
dryer retaining bracket using a
Phillips screwdriver.
3
Remove the retaining bracket, ensuring
the filter dryer does not touch any pipes
or the side of the rear compartment.
4
The rear bracket should only be added
to the left-hand appliance as viewed
from the front.
Align the top edge of the rear bracket
to the bottom edge of the back panel.
Holes for the bracket will need to be
drilled into the side of the chassis.
Secure bracket from the side using
three of the 8x16 screws.
5
Slot the second, right-hand appliance as
viewed from the front, into the bracket,
ensuring it sits securely.
Do not fix in place.
FRONT VIEW
