Panda xControl
29.9.16
Chapter 2: Panda xControl - Page 7
2. Panda xControl
The Panda xControl is a generator control system with three main components.
2.1
Components of the xControl
2.1.1 xControl - CP-G
(
C
ontrol
P
anel –
G
enerator) - Part No. 21.02.02.204P
Fig. 2.1.1-1: Control Panel - Generator
Display and Control Element of the xControl
The xControl CP-G is the display and control element
Power is supplied via the bus cable. Multiple control
elements can be installed in a single system.
2.1.2 xControl - GC-S
(
G
enerator
C
ontrol -
S
ervo) - Part.No. 21.02.08.019P
Fig. 2.1.2-1: Generator Control - Servo
Main module of the xControl.
The module contains the control electronics
The xControl GC-S is usually installed in the generator
capsule.
The xControl GC-S takes over the monitoring and control of
the diesel engine of the Fischer Panda generator, as well as
the control of the output voltage and frequency of the
generator.
The xControl GC-S is suitable for 12V and 24 V starting systems. The connected actuators are supplied with power
via switching outputs with input voltage.
Current measurement is single-phase and can be done directly.
A voltage sensor is not necessary.
Current
measurement takes place via an external current sensor. An additional three-phase module can be used for three-
phase generators.
2.1.3 xControl - CB-G
(
C
onnection
B
ox -
G
enerator)
Fig. 2.1.3-1: Connection Box - Generator
The xControl GC-S is usually installed in the generator
capsule (externally).
The xControl CB-G is the external terminal block for the
xControl generator.
The control element and the fuel pump are connected here.
